GENERATOR REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. B000NJT

      Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 retainers on the front of the V-bank cover sub-assembly. Continue to raise the V-bank cover sub-assembly to disengage the retainer on the rear of the V-bank cover sub-assembly and remove the V-bank cover sub-assembly.

      Note

      Attempting to disengage both front and rear retainers at the same time may cause the V-bank cover sub-assembly to break.

  4. REMOVE RADIATOR ASSEMBLY

    Click here.

  5. REMOVE V-RIBBED BELT

    Click here.

  6. REMOVE GENERATOR ASSEMBLY


    1. B000NAO

      Remove the terminal cap.

    2. Remove the nut and disconnect the wire harness from terminal B.

    3. Disconnect the generator connector from the generator assembly.

    4. Remove the bolt and disconnect the wire harness clamp.

    5. B000IOX

      Remove the 2 bolts.

    6. B000K4J

      Remove the 2 bolts and generator assembly.

    7. Disconnect the wire harness clamp and remove the generator bracket.