BLIND SPOT MONITOR SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips


  • Use the following procedure to troubleshoot the blind spot monitor system.

  • *: Use the GTS.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. CUSTOMER PROBLEM ANALYSIS


    NEXT

  3. INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.


      NEXT

  4. CHECK CAN COMMUNICATION SYSTEM*


    1. Use the GTS to check if the CAN communication system is functioning normally Click here.

      Result
      Result Proceed to
      CAN communication system DTCs are not output. A
      CAN communication system DTCs are output. B

      B

      GO TO CAN COMMUNICATION SYSTEM Click here

      A

  5. CHECK FOR DTC AND FREEZE FRAME DATA*


    1. Refer to DTC Check / Clear Click here.

    2. Record or print DTCs and freeze frame data, if necessary Click here.

      Result
      Result Proceed to
      DTCs are output. A
      DTCs are not output. B

      B

      Go to step 9
      A

  6. CLEAR DTC*


    1. Refer to DTC Check / Clear Click here.

      Tech Tips

      The current DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.


      NEXT

  7. RECHECK FOR DTC*


    1. Refer to DTC Check / Clear Click here.

      Result
      Result Proceed to
      DTCs are output. A
      DTCs are not output. B

      Tech Tips

      Even if the problem symptom is not confirmed, check for DTCs. This is because the system stores history DTCs.


      B

      Go to step 9
      A

  8. DIAGNOSTIC TROUBLE CODE CHART


    1. Find the output DTC in Diagnostic Trouble Code Chart Click here.


      NEXT
      Go to step 11

  9. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table Click here.

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table. A
      Fault is listed in Problem Symptoms Table. B

      Tech Tips

      If the symptom does not recur and no DTC is output, attempt to reproduce the symptoms Click here.


      B

      Go to step 11
      A

  10. PERFORM TROUBLESHOOTING BASED ON PROBLEM SYMPTOM*


    1. Refer to Terminals of ECU Click here.

    2. Refer to Data List / Active Test Click here.


      NEXT

  11. CIRCUIT INSPECTION


    NEXT

  12. ADJUST, REPAIR OR REPLACE


    NEXT

  13. PERFORM BEAM AXIS INSPECTION AND CONFIRMATION


    1. Enter Test Mode (refer to Blind Spot Monitor Beam Axis Inspection) Click here.

    2. Check the blind spot monitor beam axis display and perform the blind spot monitor beam axis adjustment Click here.


      NEXT

  14. PERFORM CONFIRMATION TEST*


    NEXT
    END