NAVIGATION RECEIVER (for TMC, TMMR Made) INSTALLATION


  1. INSTALL NAVIGATION RECEIVER ASSEMBLY

  2. INSTALL AIR CONDITIONING CONTROL ASSEMBLY


    1. Engage the 4 clips to install the air conditioning control assembly.

  3. INSTALL NO. 1 RADIO BRACKET


    1. Install the No. 1 radio bracket with the 4 screws.

  4. INSTALL NO. 2 RADIO BRACKET


    1. Install the No. 2 radio bracket with the 4 screws.

  5. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY


    1. Connect each connector.

    2. Engage the 6 clips to the vehicle body to temporarily install the navigation receiver assembly with air conditioning control assembly.

    3. Install the navigation receiver assembly with air conditioning control assembly with the 4 bolts.

  6. INSTALL FRONT CONSOLE UPPER PANEL GARNISH


    1. for Blank Type:


      1. B000HOA

        Engage the 2 claws to install the front console upper panel garnish as shown in the illustration.

    2. for 3 Switch Hole Type:


      1. Connect each connector.

      2. B000N2U

        Engage the 2 claws to install the front console upper panel garnish as shown in the illustration.

  7. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY


    1. Connect the connector.

    2. B000LVO

      Engage the 4 clips to install the No. 2 instrument panel register assembly.

      Note

      When installing the No. 2 instrument panel register assembly, check that the wire harness is not caught between the No. 2 instrument panel register assembly and duct.

  8. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. B000NS6

      Engage the 7 clips and 2 guides to install the center instrument cluster finish panel sub-assembly.

  9. INSTALL FRONT PANEL GARNISH LH


    1. B000N75

      Engage the 3 clips and 8 guides to install the front panel garnish LH.

  10. INSTALL FRONT PANEL GARNISH RH


    1. B000KNC

      Engage the 3 clips and 8 guides to install the front panel garnish RH.

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.