NAVIGATION SYSTEM (for Radio and Display Type) Mute Signal Circuit between Stereo Component Amplifier and Telematics Transceiver

DESCRIPTION

The telematics transceiver sends a mute signal to the stereo component amplifier assembly.

The stereo component amplifier assembly controls the volume according to the mute signal from the telematics transceiver.

WIRING DIAGRAM

B000JSKE99

INSPECTION PROCEDURE

Note

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System Click here.

PROCEDURE


  1. INSPECT TELEMATICS TRANSCEIVER


    1. B000HFUE06
      Text in Illustration
      *a

      Component with harness connected

      (Telematics Transceiver)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      I218-17 (MUTE) - Body ground

      Ignition switch ACC

      Audio system playing

      → Emergency call mode

      2.0 V or higher

      → Below 1 V

    NG

    CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - TELEMATICS TRANSCEIVER) Click here

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

  2. CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - TELEMATICS TRANSCEIVER)


    1. Disconnect the I69 stereo component amplifier assembly connector.

    2. Disconnect the I218 telematics transceiver connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      I69-24 (TMUT) - I218-17 (MUTE) Always Below 1 Ω
      I69-24 (TMUT) or I218-17 (MUTE) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY


    1. Disconnect the I218 telematics transceiver connector.

    2. B000JRFE48
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Telematics Transceiver)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      I218-17 (MUTE) - Body ground Ignition switch ACC 2.0 V or higher

    NG

    REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY Click here

    OK

    REPLACE TELEMATICS TRANSCEIVER Click here