RADIO ANTENNA CORD (for TMC, TMMR Made) REMOVAL


  1. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY

    Click here

  2. REMOVE NO. 3 HEATER TO REGISTER DUCT (for LHD)


    1. B000MPB

      Remove the clip.

    2. Remove the 3 screws <C> and No. 3 heater to register duct.

  3. REMOVE HEATER TO REGISTER DUCT ASSEMBLY (for RHD)


    1. B000IP2

      Remove the clip.

    2. Remove the 3 screws <C>.

    3. Disengage the heater to register duct assembly from the ion generator assembly, to remove the heater to register duct.

  4. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT


    1. B000LL0

      Remove the screw <C>.

    2. Disengage the 2 claws to remove the No. 2 side defroster nozzle duct.

  5. REMOVE ANTENNA CORD SUB-ASSEMBLY


    1. for LHD:


      1. Disengage the 8 clamps and remove the antenna cord sub-assembly.

        B000LB7

    2. for RHD:


      1. Disengage the 10 clamps and remove the antenna cord sub-assembly.

        B000NSH

  6. REMOVE ROOF HEADLINING ASSEMBLY

    Click here

  7. REMOVE NO. 1 ROOF SILENCER PAD (w/o Sliding Roof)


    1. w/ Television Antenna: Click here

  8. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY


    1. Peel back the tape used to secure the antenna cord only to the extent that allows removal of the No. 2 antenna cord sub-assembly.

      Tech Tips

      Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining so that the tape can be reused.

    2. Remove the No. 2 antenna cord sub-assembly from the roof headlining.

      B000N1YE01
      Text in Illustration
      *A w/o Sliding Roof *B w/ Sliding Roof
      *C w/ Television Antenna - -
      B000IB9 Front B000JL5 Tape