INSTRUMENT PANEL SPEAKER (for TMMK Made) REMOVAL

Note


    for Side:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.


  1. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    1. B000KDO

      Disconnect the front door opening trim weatherstrip LH.

  2. REMOVE FRONT PILLAR GARNISH


    1. B000I6YE01
      Text in Illustration
      *1 Front Pillar Garnish Clip

      Pull the upper part of the garnish toward the inside of the cabin and disengage the garnish from the base of the 2 clips.

      Tech Tips

      Make the front pillar garnish LH hang from the front pillar garnish clip.

    2. B000K0CE02

      While pushing the tabs of the front pillar garnish clip in the direction indicated by the arrows (A) shown in the illustration, disengage the front pillar garnish clip.

      Note

      Do not apply excessive force using a tool.

    3. Pull the garnish in the direction indicated by the arrow (B) shown in the illustration to disengage the 2 guides and remove the front pillar garnish LH.

    4. Remove the 2 clips from the front pillar garnish LH.

    5. B000KY7E02
      Text in Illustration
      *1 Curtain Shield Airbag Assembly LH
      *a Protective Cover
      B000JL5 Adhesive Tape

      Protect the curtain shield airbag assembly LH.


      1. Cover the curtain shield airbag assembly LH with a piece of cloth or nylon and secure the edges of the cover with tape as shown in the illustration.

        Note

        Cover the curtain shield airbag assembly LH with a protective cover as soon as the front pillar garnish LH is removed.

  3. REMOVE INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY


    1. B000HLK

      Apply protective tape to the area shown in the illustration.

      Text in Illustration
      B000JL5 Protective Tape
    2. B000I0I

      Using a moulding remover, disengage the 2 clips and 3 claws.

    3. Disengage the 2 guides to remove the No. 1 instrument panel speaker panel sub-assembly.

  4. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY

    Note

    Do not touch the speaker cone.


    1. B000I7F

      Remove the 2 screws.

    2. Lift the front No. 2 speaker assembly and disconnect the connector to remove the speaker.

  5. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY (for 10 Speakers)


    1. B000IYK

      Using a moulding remover, disengage the 11 clips as shown in the illustration.

    2. Disconnect the connector to remove the No. 1 speaker opening cover assembly.

  6. REMOVE FRONT NO. 3 SPEAKER ASSEMBLY (for 10 Speakers)

    Note

    Do not touch the speaker cone.


    1. B000I7L

      Remove the 2 screws.

    2. Lift the front No. 3 speaker assembly and disconnect the connector to remove the speaker.