FRONT DOOR SPEAKER (for TMC, TMMR Made) REMOVAL


  1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG


    1. B000H8O

      Using a moulding remover, disengage the 3 claws and remove the front door inside handle bezel plug as shown in the illustration.

  2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH


    1. B000LAY

      Disengage the 3 clips and remove the front door lower frame bracket garnish.

  3. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)


    1. B000MRM

      Using a moulding remover, disengage the 2 clips, 5 claws and 4 guides as shown in the illustration.

    2. Disconnect each connector and remove the multiplex network master switch assembly with front door armrest base panel.

  4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)


    1. B000HBZ

      Using a moulding remover, disengage the 2 clips, 5 claws and 4 guides as shown in the illustration.

    2. Disconnect the connector and remove the power window regulator switch assembly with front door armrest base panel.

  5. REMOVE FRONT ARMREST ASSEMBLY


    1. B000N26

      Using a moulding remover, disengage the 3 clips, 7 claws and 2 guides and remove the front armrest assembly.

  6. REMOVE COURTESY LIGHT ASSEMBLY


    1. B000NPFE01
      Text in Illustration
      *A for LH Side
      *B for RH Side
      *1 Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, disengage the claw.

    2. Disconnect the connector and remove the courtesy light assembly.

  7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    1. B000LS6E01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the front door panel.

    2. B000NJZ

      Remove the 3 screws.

    3. Using a clip remover, disengage the 10 clips.

    4. B000NQ1E01
      Text in Illustration
      *1 Reference Boss
      *2 Front Door Inner Glass Weatherstrip

      Pull out the front door trim board sub-assembly in the direction indicated by the arrow as shown in the illustration.

    5. Disengage the reference boss from the front door panel.

    6. Raise the front door trim board sub-assembly to remove the front door trim board sub-assembly together with the front door inner glass weatherstrip.

    7. w/o Memory:


      1. Disconnect the connector.

    8. w/ Memory:


      1. Disconnect the 2 connectors.

    9. B000IDX

      Disconnect the front door lock remote control cable assembly and front door inside locking cable assembly.

  8. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP


    1. B000L90E01
      Text in Illustration
      *1 Screwdriver

      Using a screwdriver, disengage the 4 claws and remove the front door inner glass weatherstrip from the front door trim board sub-assembly as shown in the illustration.

  9. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


    1. B000I5O

      Disconnect the connector.

    2. Remove the 4 screws.

    3. B000MIX

      Disengage the 2 claws and remove the front No. 1 speaker assembly.

      Note

      Do not touch the speaker cone.