FRONT DOOR SPEAKER (for TMMK Made) REMOVAL

Note


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.


  1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG


    1. B000JHU

      Using a moulding remover, disengage the 3 claws to remove the front door inside handle bezel plug as shown in the illustration.

  2. REMOVE FRONT DOOR FRONT LOWER FRAME UPPER COVER


    1. B000JC8

      Disengage the 2 claws and 2 guides to remove the front door front lower frame upper cover.

  3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)


    1. B000MJ9

      Using a moulding remover, disengage the 2 clips, 6 claws and 3 guides.

    2. Disconnect each connector to remove the power window regulator master switch assembly with front door armrest base panel.

  4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)


    1. B000IX3

      Using a moulding remover, disengage the 2 clips, 6 claws and 3 guides.

    2. Disconnect each connector to remove the power window regulator switch assembly with front door armrest base panel.

  5. REMOVE FRONT ARMREST ASSEMBLY


    1. B000N26

      Using a moulding remover, disengage the 3 clips, 7 claws and 2 guides to remove the front armrest assembly.

  6. REMOVE COURTESY LIGHT ASSEMBLY


    1. B000NPFE01
      Text in Illustration
      *A for LH Side
      *B for RH Side
      *1 Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, disengage the claw.

    2. Disconnect the connector and remove the courtesy light assembly.

  7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    1. B000KMQE01
      Text in Illustration
      *a Protective Tape

      Apply protective tape to the front door panel.

    2. B000LET

      Remove the 3 screws.

    3. Using a clip remover, disengage the 10 clips.

    4. B000LEFE01
      Text in Illustration
      *1 Front Door Inner Glass Weatherstrip
      *a Reference Boss

      Pull out the front door trim board sub-assembly as shown in the illustration.

    5. Disengage the reference boss from the front door panel.

    6. Raise the front door trim board sub-assembly to remove the front door trim board sub-assembly together with the front door inner glass weatherstrip.

    7. B000M72

      Disengage the clamp.

    8. Disconnect the front door lock remote control cable assembly and front door inside locking cable assembly as shown in the illustration.

  8. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP


    1. B000H3BE01
      Text in Illustration
      *a Screwdriver

      Using a screwdriver, disengage the 4 claws and remove the front door inner glass weatherstrip from the front door trim board sub-assembly as shown in the illustration.

  9. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

    Note

    Do not touch the speaker cone.


    1. B000I5O

      Disconnect the connector.

    2. Remove the 4 screws.

    3. B000MIX

      Disengage the 2 claws and remove the front No. 1 speaker assembly.