STEERING WHEEL INSTALLATION

Note


  • Do not replace the spiral cable with the battery connected and the ignition switch ON.

  • Do not rotate the spiral cable without the steering wheel with the battery connected and the ignition switch ON.

  • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.


  1. INSTALL STEERING SHAKE DAMPER


    1. Install the steering shake damper to the steering wheel sub-assembly with the 2 screws.

      Torque:
      2.4 N*m  { 24 kgf*cm, 21 in.*lbf }

  2. CONNECT NO. 1 SWITCH WIRE (w/ Shift Paddle Switch)


    1. Connect the 2 No. 1 switch wire connectors to the 2 shift paddle switches (transmission shift switch assembly).

    2. B000JIXE01
      Text in Illustration
      *1 Clamp
      *a 0 to 40°
      *b 1 to 3 mm

      Install new 2 clamps as shown in the illustration.

    3. Engage the 5 guides to install the No. 1 switch wire.

  3. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (w/ Shift Paddle Switch)


    1. Engage the 4 pins and install the 2 shift paddle switches (transmission shift switch assembly) with the 2 screws.

      Torque:
      1.3 N*m  { 13 kgf*cm, 12 in.*lbf }

      Note

      Make sure that the brackets are securely installed.

  4. INSTALL CRUISE CONTROL SWITCH WIRE (w/ Cruise Control System)


    1. Install the cruise control switch wire.

  5. INSTALL CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)


    1. Connect the connector.

    2. B000H4A

      Install the cruise control switch with the 2 screws shown in the illustration.

      Torque:
      2.4 N*m  { 24 kgf*cm, 21 in.*lbf }

  6. INSTALL STEERING PAD SWITCH ASSEMBLY


    1. Engage the 2 claws, 2 pins and 2 guides to install the steering pad switch assembly.

    2. Install the 2 screws.

      Torque:
      2.4 N*m  { 24 kgf*cm, 21 in.*lbf }

    3. w/ Shift Paddle Switch Wire of Steering Pad Switch Assembly:


      1. Engage the clamp.

    4. Connect the steering pad switch connector to the spiral cable sub-assembly.

    5. B000I16

      Pass the wire harness over the 2 guides.

  7. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  8. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY


  9. INSTALL STEERING WHEEL ASSEMBLY


    1. B000J5KE01
      Text in Illustration
      *a Matchmark

      Install the steering wheel assembly aligning the matchmarks on the steering wheel assembly and steering main shaft.

    2. Install the steering wheel assembly set nut.

      Torque:
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

    3. Connect the connectors to the spiral cable sub-assembly.

  10. CHECK STEERING WHEEL CENTER POINT

  11. INSTALL HORN BUTTON ASSEMBLY