BRAKE MASTER CYLINDER (for RHD) REMOVAL

Note

Make sure to release vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.


  1. DRAIN BRAKE FLUID

    Note

    If brake fluid leaks onto any painted surface, immediately wash it off.

  2. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    Click here

  3. REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY


    1. B000L2Z

      Disengage the 2 clamps and separate the wire harness from the front outer cowl top panel sub-assembly.

    2. B000GWP

      Remove the 10 bolts and front outer cowl top panel sub-assembly.

  4. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY


    1. B000LTQ

      Disconnect the reservoir level switch connector.

    2. B000I2Y

      Using a union nut wrench, disconnect the 2 brake lines from the brake master cylinder sub-assembly.

      Note


      • Do not damage or deform the brake lines during the removal procedure.

      • Do not allow any foreign matter such as dirt or dust to enter the brake lines.

    3. B000N02E01
      Text in Illustration
      *1 Master Cylinder Piston

      Remove the 2 nuts, vacuum check valve bracket and brake master cylinder sub-assembly.

      Note


      • Do not hold the brake master cylinder sub-assembly by the master cylinder piston. Hold the brake master cylinder sub-assembly by its body or its reservoir when carrying it.

      • Do not pull out the master cylinder piston.

      • Do not strike or pinch the master cylinder piston, and do not cause any damage to the master cylinder piston by any other means.

      • When installing the brake master cylinder sub-assembly to the brake booster assembly, or when removing the brake master cylinder sub-assembly from the brake booster assembly, make sure that the brake master cylinder sub-assembly is kept horizontal or its tip faces downward (the master cylinder piston faces upward) to prevent the master cylinder piston from falling out.

      • Do not allow any foreign matter to contaminate the master cylinder piston. If any foreign matter gets on the master cylinder piston, remove it by using a piece of cloth and then apply an even layer of lithium soap base glycol grease around the circumference (sliding part) of the master cylinder piston.

      • Do not use any other types of grease.

  5. REMOVE BRAKE MASTER CYLINDER O-RING


    1. Remove the brake master cylinder O-ring from the brake master cylinder sub-assembly.