VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1381

DTC Code DTC Name
C1381 Acceleration Sensor Power Supply Voltage Malfunction

DESCRIPTION

This DTC is stored when the skid control ECU receives a sensor supply voltage malfunction signal from the yaw rate and acceleration sensor (airbag sensor assembly).

DTC No. DTC Detection Condition Trouble Area
C1381 Vehicle speed is 6 km/h (4 mph) and yaw rate and acceleration sensor power supply malfunction signal is received for 1.1 seconds or more.

  • Yaw rate and acceleration sensor power source circuit

  • Yaw rate and acceleration sensor (Airbag sensor assembly)

WIRING DIAGRAM

Refer to DTCs C1234 and C1472 Click here.

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL)


    1. B000ME2E03
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Yaw Rate and Acceleration Sensor (Airbag Sensor Assembly))

      Make sure that there is no looseness at the locking part and the connecting part of the connector.

    2. Disconnect the yaw rate and acceleration sensor (airbag sensor assembly) connector.

    3. Turn the ignition switch to ON.

    4. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      I47-21 (IG2) - Body ground Ignition switch ON 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)

    OK

  2. CHECK HARNESS AND CONNECTOR (GROUND TERMINAL)


    1. B000ME2E04
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Yaw Rate and Acceleration Sensor (Airbag Sensor Assembly))

      Turn the ignition switch off.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      I47-25 (E1) - Body ground Always Below 1 Ω
      I47-26 (E2) - Body ground Always Below 1 Ω
      Result
      Result Proceed to
      OK (for TMC, TMMR Made) A
      OK (for TMMK Made) B
      NG C

      Tech Tips

      If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts Click here.


    B

    REPLACE AIRBAG SENSOR ASSEMBLY Click here

    C

    REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT)

    A

    REPLACE AIRBAG SENSOR ASSEMBLY Click here