FRONT DOOR BELT MOULDING (for TMC, TMMR Made) REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY

    Click here

  4. REMOVE FRONT DOOR SERVICE HOLE COVER


    1. B000M0M

      Disconnect each connector.

    2. Disengage the 4 clamps.

    3. Remove the front door service hole cover.

      Tech Tips

      Remove any remaining butyl tape from the door.

  5. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY


    1. B000LXE

      Remove the grommet.

    2. Connect the cable to the negative (-) battery terminal.

    3. Connect the multiplex network master switch assembly and move the front door glass sub-assembly so that the door glass bolts can be seen.

    4. Disconnect the cable from the negative (-) battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    5. Disconnect the multiplex network master switch assembly.

    6. B000HBB

      Remove the 2 bolts.

      Note

      After the bolts are removed, do not allow the door glass to fall.

    7. B000M3GE01

      Remove the front door glass sub-assembly as indicated by the arrows, in the order shown in the illustration.

      Note

      Do not damage the door glass.

  6. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY


    1. B000J0RE01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the front door belt moulding assembly.

    2. B000I89E01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and remove the front door belt moulding assembly.