FRONT BUMPER (for TMC, TMMR Made) REMOVAL


  1. REMOVE COOL AIR INTAKE DUCT SEAL


    1. B000MPY

      Remove the 9 clips and cool air intake duct seal.

  2. REMOVE FRONT BUMPER ASSEMBLY


    1. B000HNX

      Apply protective tape around the front bumper assembly as shown in the illustration.

      Text in Illustration
      B000JL5 Protective Tape
    2. B000IGH

      Remove the 8 screws.

    3. B000M6PE01
      Text in Illustration
      *1 Pin Hold Clip
      *a 90°

      Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. Remove the clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    5. B000KL0

      Disengage the 3 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    6. Pull back the side of the front bumper assembly and disconnect each connector.

      Note

      Do not apply excessive force when pulling back the front bumper assembly.

    7. B000JD5

      Remove the bolt and 2 screws.

    8. Remove the 2 clips.

    9. w/ Headlight Cleaner System:


      1. B000JNO

        Disconnect the headlight cleaner hose and drain the washer fluid.

        Tech Tips

        Use a container to collect the washer fluid.

    10. Remove the front bumper assembly.