FRONT BUMPER (for TMMK Made) REMOVAL


  1. REMOVE COOL AIR INTAKE DUCT SEAL


    1. B000JM6

      Remove the 9 clips and cool air intake duct seal.

  2. REMOVE FRONT BUMPER ASSEMBLY


    1. B000N0F

      Apply protective tape around the front bumper assembly as shown in the illustration.

      Text in Illustration
      B000JL5 Protective Tape
    2. B000K9I

      Remove the 7 screws.

    3. B000H8FE01
      Text in Illustration
      *1 Pin Hold Clip
      *a 90°

      Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. Remove the clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    5. B000LKVE01
      Text in Illustration
      *a Screwdriver
      B000JL5 Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, disengage the 3 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    6. Pull back the side of the front bumper assembly and disconnect the 2 daytime running light connectors.

      Note

      Do not apply excessive force when separating the front bumper assembly.

    7. B000ISN

      Using a clip remover, remove the clip and 2 hood center cushions.

    8. B000KH3

      Remove the 2 bolts.

    9. B000LVC

      Remove the front bumper assembly as shown in the illustration.