SIDE TURN SIGNAL LIGHT ASSEMBLY (for TMC, TMMR Made) REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.


  1. REMOVE OUTER MIRROR (w/o Memory)


    1. B000IVLE04
      Text in Illustration
      *a Protective Tape

      Apply protective tape to the area shown in the illustration.

    2. Push the upper part of the mirror surface and tilt it.

    3. B000N7PE03
      Text in Illustration
      *a Moulding Remover

      Using a moulding remover, disengage the 2 claws at the lower part of the outer mirror as shown in the illustration.

    4. B000N7B

      Disengage the 2 guides as shown in the illustration.

    5. B000JJA

      Disconnect the 2 connectors and remove the outer mirror.

  2. REMOVE OUTER MIRROR (w/ Memory)


    1. B000J1TE01
      Text in Illustration
      *a Protective Tape

      Apply protective tape to the area shown in the illustration.

    2. Push the upper part of the mirror surface and tilt it.

    3. Using a moulding remover, disengage the 2 claws at the lower part of the outer mirror as shown in the illustration.

    4. B000LTBE01
      Text in Illustration
      *a Protective Tape

      Apply protective tape to the area shown in the illustration.

    5. Push the lower part of the mirror surface and tilt it.

    6. Using a moulding remover, disengage the 2 claws at the upper part of the outer mirror as shown in the illustration.

    7. B000N34E01
      *a Mirror Heater Connector
      *b Blind Spot Monitor Indicator Connector

      Disconnect the mirror heater connector.

    8. Disengage the 2 claws.

    9. Using a screwdriver, release the tabs of the blind spot monitor indicator connector to disconnect the connector and remove the outer mirror.

      Note


      • Do not bend the tabs excessively to prevent them from being damaged.

      • If the tabs are damaged, replace the outer mirror with a new one.

  3. REMOVE OUTER MIRROR COVER (w/o Memory)


    1. B000MA7

      Remove the 3 screws.

    2. B000KBA

      Disengage the clamp.

    3. Disconnect the 2 connectors and remove the mirror actuator.

    4. B000KWM

      Disengage the 7 claws and remove the outer mirror cover.

  4. REMOVE OUTER MIRROR COVER (w/ Memory)


    1. B000LE7

      Disengage the 5 claws.

    2. B000JJOE01

      Disengage the 2 claws to remove the outer mirror cover as shown in the illustration.

      Tech Tips

      When removing the outer mirror cover, pull the outer mirror cover horizontally along the lower part of the outer rear view mirror assembly.

  5. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY


    1. B000LBC

      Disengage the 2 claws.

    2. Disconnect the connector and remove the side turn signal light assembly.