AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM FAIL-SAFE CHART


  1. AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM


    1. The headlight leveling ECU assembly operates in fail-safe mode if an abnormal condition such as those listed below has been detected, and keep the last low beam status.

      Item Abnormality Detection Condition Return Condition Multi-information Display
      Height control sensor power source voltage Abnormal height control sensor power source voltage (4.6 V or less, or 6.25 V or more) is detected. Abnormal voltage is not detected for 5 seconds consecutively

      • "Check Headlight System" is displayed.*1

      • "Check Headlight Leveling System" is displayed.*2
      Height control sensor signal voltage Abnormal height control sensor signal voltage (0.25 V or less, or 4.75 V or more) is detected.
      High power source voltage Abnormal high IG supply voltage (18.5 V or more) is detected. Voltage of 17.5 V or less is detected

      • "Check Headlight System" is not displayed.*1

      • "Check Headlight Leveling System" is not displayed.*2
      Low power source voltage Abnormal low IG supply voltage (9.0 V or less) is detected. Voltage of 9.3 V or more is detected for 0.1 seconds consecutively

      • "Check Headlight System" is not displayed.*1

      • "Check Headlight Leveling System" is not displayed.*2
      Reset while running Reset by a temporary loss of power etc. while driving. Vehicle is stopped

      • "Check Headlight System" is not displayed.*1

      • "Check Headlight Leveling System" is not displayed.*2

      • *1: for TMC, TMMR Made

      • *2: for TMMK Made