LIGHTING SYSTEM Taillight Relay Circuit

DESCRIPTION

The main body ECU (multiplex network body ECU) controls the operation of the TAIL relay.

WIRING DIAGRAM


  1. for TMC, TMMR Made:

    B000KRFE04

  2. for TMMR Made:

    B000IOBE03

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / Main Body / Active Test.

    5. Check that the relay operates.

      Main Body
      Tester Display Test Part Control Range Diagnostic Note
      Taillight Relay Taillight relay ON/OFF -
      OK
      Taillight relay operates. (Taillights illuminate.)

    NG

    CHECK HARNESS AND CONNECTOR (BATTERY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) Click here

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

  2. CHECK HARNESS AND CONNECTOR (BATTERY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)


    1. Disconnect the 3E*1 or 3F*2 instrument panel junction block assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      3E-1*1 - Body ground Always 11 to 14 V
      3F-1*2 - Body ground Always 11 to 14 V

      • *1: for LHD

      • *2: for RHD


    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


    1. Remove the instrument panel junction block assembly Click here.

    2. Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.

      B000JKRE03

    3. Connect a positive (+) lead from the battery to terminal 3E-1*1 or 3F-1*2.

    4. Connect a negative (-) lead from the battery to terminal MB-14.

    5. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      3D-3 - Battery negative terminal*3 Always 11 to 14 V
      3D-6 - Battery negative terminal*3 Always 11 to 14 V
      3D-7 - Battery negative Always 11 to 14 V
      3D-8 - Battery negative Always 11 to 14 V
      3C-5 - Battery negative Always 11 to 14 V

      • *1: for LHD

      • *2: for RHD

      • *3: for TMMK Made

      Text in Illustration
      *A for LHD *B for RHD
      *a

      Component without harness connected

      (Instrument Panel Junction Block Assembly)

      		 - -

    NG

    REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY Click here

    OK

    REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here