OIL PUMP REMOVAL

Note

Do not remove the oil pump or oil pump relief valve from the timing chain cover sub-assembly.


  1. REMOVE ENGINE AND TRANSAXLE

    Click here

  2. REMOVE ENGINE WIRE

  3. REMOVE IGNITION COIL ASSEMBLY


    1. Disconnect the 4 ignition coil assembly connectors.

    2. B000LI6

      Remove the 4 bolts and 4 ignition coil assemblies.

  4. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY


    1. B000I28

      Remove the 16 bolts, 3 seal washers, cylinder head cover and gasket.

    2. B000NHO

      Remove the 3 gaskets from the camshaft bearing caps.

  5. REMOVE CRANKSHAFT POSITION SENSOR

    B000JIE

    1. Disconnect the crankshaft position sensor connector.

    2. Remove the bolt and crankshaft position sensor.

  6. REMOVE CRANKSHAFT PULLEY


    1. B000ID4E05
      Text in Illustration
      *a Hold
      *b Turn

      Using SST, hold the crankshaft pulley and loosen the pulley bolt. Further loosen the bolt until 2 or 3 threads are screwed into the crankshaft.

      SST
      09213-54015
      09330-00021

      Tech Tips

      SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650(2 pcs)

    2. B000M9LE02
      Text in Illustration
      *1 Pulley Bolt
      *a Hold
      *b Turn

      Using SST and the pulley bolt, remove the crankshaft pulley.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05011 )

      Tech Tips

      Apply a lubricant to the threads and end of SST.

  7. REMOVE ENGINE MOUNTING BRACKET RH


    1. B000NI8

      Remove the 5 bolts and engine mounting bracket RH.

  8. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY


    1. B000IMS

      Remove the bolt and V-ribbed belt tensioner.

  9. REMOVE TIMING CHAIN COVER SUB-ASSEMBLY


    1. B000HE1

      Remove the 17 bolts and 2 nuts.

    2. B000K5M

      Remove the timing chain cover by prying between the timing chain cover and cylinder head, camshaft housing, cylinder block and stiffening crankcase with a screwdriver as shown in the illustration.

      Note

      Be careful not to damage the contact surfaces of the cylinder head, camshaft housing, cylinder block, stiffening crankcase or chain cover.

      Tech Tips

      Tape the screwdriver tip before use.

    3. B000IPX

      Remove the 3 gaskets from the stiffening crankcase.

  10. REMOVE TIMING CHAIN COVER OIL SEAL


    1. B000JGYE04
      Text in Illustration
      *1 Wooden Block

      Using a screwdriver and wooden block, pry out the oil seal.

      Note

      Do not damage the surface of the oil seal press fit hole.

      Tech Tips

      Tape the screwdriver tip before use.