OIL PRESSURE SENSOR INSTALLATION


  1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY


    1. B000LYQE01
      Text in Illustration
      *a Adhesive 1344
      *b Oil Inlet Port

      Apply adhesive to 2 or 3 threads of the oil pressure sender gauge assembly.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      Note


      • Do not apply adhesive to the oil inlet port of the oil pressure sender gauge assembly.

      • Install the oil pressure sender gauge assembly within 3 minutes of applying adhesive.

    2. Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

    3. Connect the oil pressure sender gauge assembly connector.

  2. INSPECT FOR OIL LEAK


    1. Start the engine. Make sure that there are no engine oil leaks from the area that was worked on.

  3. INSTALL NO. 2 ENGINE MOUNTING STAY RH


    1. Install the No. 2 engine mounting stay RH with the 2 bolts.

      Torque:
      38 N*m  { 387 kgf*cm, 28 ft.*lbf }

  4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. Engage the 3 grommets to install the No. 1 engine cover sub-assembly.