REAR CRANKSHAFT OIL SEAL REMOVAL


  1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY

    Click here

  2. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. Using height adjustment attachments and plate lift attachments, place the engine assembly on a flat level surface.

      Note


      • Using height adjustment attachments and plate lift attachments, place the engine assembly horizontally.

      • To prevent the oil pan sub-assembly from deforming, do not place any attachments under the oil pan sub-assembly of the engine assembly.

      • Using an engine sling device and engine lift, secure the engine assembly before service.

    2. B000LVTE01

      Using SST, hold the crankshaft pulley.

      SST
      09213-54015
      09330-00021

      Tech Tips

      Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-80650 (quantity: 2)

    3. B000MHZ

      Remove the 8 bolts, rear drive plate spacer, drive plate and ring gear sub-assembly and front drive plate spacer.

  3. REMOVE REAR ENGINE OIL SEAL


    1. B000NHEE01
      Text in Illustration
      *a Protective Tape
      *b Cut Position

      Using a knife, cut off the lip of the rear engine oil seal.

    2. Using a screwdriver, pry out the rear engine oil seal.

      Note

      Do not damage the surface of the rear engine oil seal press fit hole or the crankshaft.

      Tech Tips

      Tape the screwdriver tip before use.