ACCELERATOR PEDAL ON-VEHICLE INSPECTION


  1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Data List / Accelerator Position Sensor No.1 Voltage and Accelerator Position Sensor No.2 Voltage.

    5. Read the values displayed on the GTS.

      Standard Voltage
      GTS Display Condition Specified Condition
      Accelerator Position Sensor No.1 Voltage Accelerator pedal fully released 0.5 to 1.1 V
      Accelerator pedal fully depressed 2.6 to 4.5 V
      Accelerator Position Sensor No.2 Voltage Accelerator pedal fully released 1.2 to 2.0 V
      Accelerator pedal fully depressed 3.4 to 4.75 V

      If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.