ECM REMOVAL

Note


  • Perform the Vehicle Identification Number (VIN) registration when replacing the ECM Click here.

  • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE ECM


    1. B000JIZ

      Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.

      Note

      After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.

    2. Disengage the wire harness clamp.

    3. B000HXF

      Remove the 3 nuts and ECM.

      Note

      If the ECM has been struck or dropped, replace it.

  3. REMOVE NO. 1 ECM BRACKET


    1. B000H0Y

      Remove the 2 screws and No. 1 ECM bracket from the ECM.

  4. REMOVE NO. 2 ECM BRACKET


    1. B000LV8

      Remove the 2 screws and No. 2 ECM bracket from the ECM.