THROTTLE BODY REMOVAL


  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. B000KZ3

      Disengage the 3 grommets to remove the No. 1 engine cover sub-assembly.

      Note

      When removing the No. 1 engine cover sub-assembly, make sure to lift it upward. Pulling the No. 1 engine cover sub-assembly towards you may damage the No. 1 engine cover sub-assembly.

  2. DRAIN ENGINE COOLANT

    CAUTION:

    Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


    1. B000JZIE01
      Text in Illustration
      *1 Engine Under Cover LH
      *a Hose

      Connect a hose with an inside diameter of 9 mm (0.354 in.) to the radiator drain cock as shown in the illustration.

    2. Loosen the radiator drain cock plug.

    3. B000I0KE01
      Text in Illustration
      *1 Radiator Cap Sub-assembly
      *2 Radiator Drain Cock Plug

      Remove the radiator cap sub-assembly. Then drain the engine coolant.

      Tech Tips

      Collect the engine coolant in a container and dispose of it according to the regulations in your area.

    4. Disconnect the hose from the radiator drain cock.

  3. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    1. B000K14

      Slide the clip and disconnect the ventilation hose from the cylinder head cover sub-assembly.

    2. Disengage the ventilation hose clamp.

    3. B000K4H

      Disconnect the mass air flow meter sub-assembly connector.

    4. Disengage the wire harness clamp.

    5. B000JRQ

      Disconnect the union to connector tube hose from the air cleaner hose sub-assembly.

    6. Disengage the 2 air cleaner cap clamps and 2 guides.

    7. B000L1M

      Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.

  4. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    1. B000NN4

      Disconnect the throttle body with motor assembly connector.

    2. Remove the 4 bolts and throttle body with motor assembly from the intake manifold.

      Note

      If the throttle body with motor assembly has been struck or dropped, replace it.

    3. B000L5AE01
      Text in Illustration
      *1 No. 2 Water By-pass Hose
      *2 No. 3 Water By-pass Hose

      Slide the 2 clips and disconnect the No. 2 water by-pass hose and No. 3 water by-pass hose from the throttle body with motor assembly.

  5. REMOVE THROTTLE BODY GASKET


    1. B000MAL

      Remove the throttle body gasket from the intake manifold.