CAMSHAFT POSITION SENSOR REMOVAL


  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. B000KZ3

      Disengage the 3 grommets to remove the No. 1 engine cover sub-assembly.

      Note

      When removing the No. 1 engine cover sub-assembly, make sure to lift it upward. Pulling the No. 1 engine cover sub-assembly towards you may damage the No. 1 engine cover sub-assembly.

  2. REMOVE CAMSHAFT POSITION SENSOR (for Intake Side)


    1. B000IH9

      Disconnect the camshaft position sensor connector.

    2. Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.

      Note

      If the camshaft position sensor has been struck or dropped, replace it.

  3. REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side)


    1. B000J1Z

      Disconnect the camshaft position sensor connector.

    2. Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.

      Note

      If the camshaft position sensor has been struck or dropped, replace it.