ENGINE COOLANT TEMPERATURE SENSOR REMOVAL


  1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

  2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

  3. REMOVE ENGINE UNDER COVER LH

  4. REMOVE ENGINE UNDER COVER RH

  5. DRAIN ENGINE COOLANT

    Note

    Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


    1. B000JZIE01
      Text in Illustration
      *1 Engine Under Cover LH
      *a Hose

      Connect a hose with an inside diameter of 9 mm (0.354 in.) to the radiator drain cock as shown in the illustration.

    2. Loosen the radiator drain cock plug.

    3. B000I0KE01
      Text in Illustration
      *1 Radiator Cap Sub-assembly
      *2 Radiator Drain Cock Plug

      Remove the radiator cap sub-assembly. Then drain the engine coolant.

      Tech Tips

      Collect the engine coolant in a container and dispose of it according to the regulations in your area.

    4. Disconnect the hose from the radiator drain cock.

  6. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. B000H7U

      Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the engine cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.

  7. REMOVE COOL AIR INTAKE DUCT SEAL (for TMC, TMMR Made)


    1. B000MPY

      Remove the 9 clips and cool air intake duct seal.

  8. REMOVE COOL AIR INTAKE DUCT SEAL (for TMMK Made)


    1. B000JM6

      Remove the 9 clips and cool air intake duct seal.

  9. REMOVE INLET AIR CLEANER ASSEMBLY


    1. B000KJW

      Remove the 2 bolts and inlet air cleaner assembly.

  10. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. B000NC7

      Disconnect the engine coolant temperature sensor connector.

    2. B000KB7

      Remove the 2 bolts and disconnect the wire harness.

    3. B000LQDE01
      Text in Illustration
      *1 Ball Joint Lock Nut Wrench
      *2 Gasket

      Using a 19 mm ball joint lock nut wrench, remove the engine coolant temperature sensor.

    4. Remove the gasket from the engine coolant temperature sensor.