ECM INSTALLATION

INSTALL NO. 1 ECM BRACKET
1. Install the ECM bracket with the nut.
  
  Torque:
  
  12 N*m { 122 kgf*cm, 9 ft.*lbf }
2. Connect the wire harness clamp.
3. Connect the wire harness clamp.
4. Install the nut.
  
  Torque:
  
  8.0 N*m { 82 kgf*cm, 71 in.*lbf }
INSTALL ECM
1. Install the ECM brackets to the ECM with the 2 screws.
  
  Torque:
  
  3.0 N*m { 31 kgf*cm, 27 in.*lbf }
2. Temporarily install the screw (B).
3. Install the ECM with the nut.
  
  Torque:
  
  12 N*m { 122 kgf*cm, 9 ft.*lbf }
4. Install the screw (A).
  
  Torque:
  
  3.0 N*m { 31 kgf*cm, 27 in.*lbf }
5. Tighten the screw (B).
  
  Torque:
  
  3.0 N*m { 31 kgf*cm, 27 in.*lbf }
6. Connect the 2 ECM connectors and lower the 2 levers.
  Note
  
  When connecting the connectors, make sure that dirt, water or other foreign matter does not become stuck between the connectors and other part.
  
  Make sure that the 2 levers are securely locked.
7. Connect the 2 wire harness clamps.
INSTALL BATTERY

Click here
INSTALL COOL AIR INTAKE DUCT SEAL (for TMC, TMMR Made)

Click here
INSTALL COOL AIR INTAKE DUCT SEAL (for TMMK Made)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
PERFORM INITIALIZATION

Click here