ECM REMOVAL

Note

Perform the Vehicle Identification Number (VIN) registration when replacing the ECM Click here.

Tech Tips

When removing only the ECM, it is not necessary to remove the cool air intake duct seal and battery.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE COOL AIR INTAKE DUCT SEAL (for TMC, TMMR Made)


    1. B000MPY

      Remove the 9 clips and cool air intake duct seal.

  3. REMOVE COOL AIR INTAKE DUCT SEAL (for TMMK Made)


    1. B000JM6

      Remove the 9 clips and cool air intake duct seal.

  4. REMOVE BATTERY


    1. B000HQK

      Loosen the nut, and separate the positive (+) battery terminal.

    2. Loosen the nut, and remove the bolt and battery clamp.

    3. Remove the battery and battery tray.

  5. REMOVE ECM


    1. B000KJA

      Disconnect the 2 ECM connectors.


      1. Push in the locks on the 2 levers, raise the levers, and disconnect the 2 ECM connectors.

        Note

        After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting part of the connectors.

    2. B000JBLE01

      Remove the nut.

    3. Remove the screw (A).

    4. Loosen the screw (B) and remove the ECM.

    5. Remove the screw (B).

    6. B000M9Z

      Remove the 2 screws and No. 2 ECM bracket.

  6. REMOVE NO. 1 ECM BRACKET


    1. B000KOI

      Remove the nut.

    2. Disconnect the wire harness clamp.

    3. B000LXC

      Disconnect the wire harness clamp.

    4. B000MPV

      Remove the nut and No. 1 ECM bracket.