THROTTLE BODY REMOVAL


  1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

  2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

  3. REMOVE ENGINE UNDER COVER LH

  4. REMOVE ENGINE UNDER COVER RH

  5. DRAIN ENGINE COOLANT

    Note

    Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


    1. B000JZIE01
      Text in Illustration
      *1 Engine Under Cover LH
      *a Hose

      Connect a hose with an inside diameter of 9 mm (0.354 in.) to the radiator drain cock as shown in the illustration.

    2. Loosen the radiator drain cock plug.

    3. B000I0KE01
      Text in Illustration
      *1 Radiator Cap Sub-assembly
      *2 Radiator Drain Cock Plug

      Remove the radiator cap sub-assembly. Then drain the engine coolant.

      Tech Tips

      Collect the engine coolant in a container and dispose of it according to the regulations in your area.

    4. Disconnect the hose from the radiator drain cock.

  6. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. B000H7U

      Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the engine cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.

  7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. B000IC4

      Disconnect the vacuum switching valve assembly from the air cleaner hose.

    2. B000ILW

      Disconnect the mass air flow meter connector and 2 wire harness clamps from the air cleaner cap sub-assembly.

    3. B000NHN

      Separate the fuel vapor feed hose from the air cleaner hose.

    4. B000LAA

      Disconnect the ventilation hose from the cylinder head cover.

    5. B000KT6

      Loosen the hose clamp and disconnect the air cleaner hose from the throttle with motor body assembly.

    6. B000NMO

      Release the 2 clamps and remove the air cleaner cap sub-assembly.

  8. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY


    1. B000GYB

      Disconnect the fuel tube from the clamp.

    2. Disconnect the throttle body connector.

    3. B000JKF

      Disconnect the water by-pass hose from the throttle with motor body assembly.

    4. Disconnect the No. 2 water by-pass hose from the throttle with motor body assembly.

    5. B000KIQ

      Remove the 4 bolts and the throttle body with fuel tube bracket.

    6. B000I82

      Remove the bolt and fuel tube bracket.

    7. B000LGR

      Remove the gasket from the intake manifold.