SFI SYSTEM DTC CHECK / CLEAR

Note

When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data recorded in normal mode are cleared. Before changing modes, always check and make a note of DTCs and freeze frame data.

Tech Tips


  • DTCs which are stored in the ECM can be displayed on the intelligent tester. The tester can display the current and pending DTCs.

  • Some DTCs are not set if the ECM does not detect the same malfunction again during a second consecutive driving cycle. However, such malfunctions, detected on only one occasion, are stored as pending DTCs.


  1. CHECK DTC


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the tester on.

    4. Enter the following menus: Powertrain / Engine and ECT / DTC.

    5. Check the DTC(s) and freeze frame data, and then save or write them down.

    6. Check the details of the DTC(s) Click here.

  2. CLEAR DTC (Using the intelligent tester)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the tester on.

    4. Enter the following menus: Powertrain / Engine and ECT / DTC.

    5. Clear the DTCs.

  3. CLEAR DTC (Without using the intelligent tester)


    1. Perform either one of the following operations:

      Note

      After turning ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.


      1. Disconnect the cable from the negative (-) battery terminal for more than 1 minute.

      2. Remove the EFI NO. 1 and ETCS fuses from the engine room relay block and junction block assembly, located inside the engine compartment for more than 1 minute.