TIRE PRESSURE WARNING RECEIVER INSTALLATION


  1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER

    Note


    • Do not drop, strike or otherwise subject the tire pressure warning ECU and receiver to impact.

    • If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.


    1. B000NKY

      Connect the connector.

    2. B000JYS

      Engage the 2 guides and install the tire pressure warning ECU and receiver with the bolt.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

  2. INSTALL ROOF SIDE INNER GARNISH LH


    1. Install 5 new clips to the roof side inner garnish LH.

    2. Engage the guide.

    3. Engage the 5 clips to install the roof side inner garnish LH.

  3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH


    1. B000JVDE02
      Text in Illustration
      *a Alignment Mark (Pink)

      Align the alignment mark (Pink) on the weatherstrip with the protruding portion on the vehicle body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip LH.

      Note

      After installation, check that the corners fit correctly.

  4. INSTALL REAR SIDE SEATBACK ASSEMBLY LH


    1. Engage the hook.

    2. Install the rear side seatback assembly LH with the 2 bolts.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

    3. Connect the connector.

    4. Connect the rear seat outer belt assembly to the rear seat shoulder belt guide.

  5. INSTALL REAR SEAT CUSHION LOCK HOOK


    1. B000HKU

      Engage the 2 claws to install a new rear seat cushion lock hook as shown in the illustration.

      Note

      Rear seat cushion lock hooks must not be reused.

      Tech Tips

      Use the same procedure for the RH side and the LH side.

  6. INSTALL REAR SEAT CUSHION ASSEMBLY


    1. Place the rear seat cushion assembly in the cabin.

      Note

      Be careful not to damage the vehicle body.

    2. Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly.

    3. B000KWO

      Engage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly to the 2 rear seat cushion lock hooks as shown in the illustration.

    4. Confirm that the rear seat cushion assembly is securely installed.

      Note

      When installing the rear seat cushion assembly, make sure that the seat belt buckles are not under the rear seat cushion assembly.

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. REGISTER TRANSMITTER ID

    Click here

  9. INSPECT TIRE PRESSURE WARNING SYSTEM

    Click here

  10. PERFORM INITIALIZATION

    Click here

  11. INSPECT SRS WARNING LIGHT

    Click here