TRANSMISSION CONTROL CABLE REMOVAL


  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. B000KZ3

      Disengage the 3 grommets to remove the No. 1 engine cover sub-assembly.

      Note

      When removing the No. 1 engine cover sub-assembly, make sure to lift it upward. Pulling the No. 1 engine cover sub-assembly towards you may damage the No. 1 engine cover sub-assembly.

  2. REMOVE COOL AIR INTAKE DUCT SEAL


    1. B000MPY

      Remove the 9 clips and cool air intake duct seal.

  3. REMOVE INLET AIR CLEANER ASSEMBLY


    1. B000NQI

      Remove the 2 bolts and inlet air cleaner assembly.

  4. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    1. B000K14

      Slide the clip and disconnect the ventilation hose from the cylinder head cover sub-assembly.

    2. Disengage the ventilation hose clamp.

    3. B000K4H

      Disconnect the mass air flow meter sub-assembly connector.

    4. Disengage the wire harness clamp.

    5. B000JRQ

      Disconnect the union to connector tube hose from the air cleaner hose sub-assembly.

    6. Disengage the 2 air cleaner cap clamps and 2 guides.

    7. B000L1M

      Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.

  5. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY


    1. Remove the air cleaner filter element sub-assembly from the air cleaner case sub-assembly.

  6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. B000LJY

      Disconnect the wire harness clamp.

    2. Remove the 2 bolts and air cleaner case sub-assembly.

  7. REMOVE AIRBAG SENSOR ASSEMBLY

    Click here

  8. REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY

    Click here

  9. DISCONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY


    1. Turn back the floor carpet.

    2. B000KO3

      Remove the bolt and nut, and disconnect the No. 1 parking brake cable assembly from the vehicle body.

  10. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. B000K75

      Disconnect the end of the transmission control cable assembly from the lower shift lever assembly.

    3. Disengage the 2 claws and disconnect the transmission control cable assembly from the lower shift lever assembly.

    4. B000J0M

      Remove the nut from the wire harness clamp bracket.

    5. Disengage the clamp and disconnect the engine wire from the automatic transaxle assembly.

    6. B000LPE

      Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.

    7. B000IEP

      Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.

    8. B000KJJE02
      Text in Illustration
      *a Dash Panel Insulator

      Turn back the dash panel insulator.

    9. Remove the 2 bolts and transmission control cable assembly.