PARK / NEUTRAL POSITION SWITCH ADJUSTMENT


  1. REMOVE TRANSMISSION CONTROL SHAFT LEVER

    Click here

  2. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. B000J3X

      Loosen the 2 bolts of the park/neutral position switch assembly.

    2. B000KX4E10
      Text in Illustration
      *a Protrusion

      Align the protrusions of the park/neutral position switch assembly as shown in the illustration.

    3. Hold the park/neutral position switch assembly in position and tighten the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Note

      After installing the park/neutral position switch assembly, confirm that the 2 protrusions on the park/neutral position switch assembly are aligned.

  3. INSTALL TRANSMISSION CONTROL SHAFT LEVER

    Click here

  4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION


    1. Apply the parking brake.

    2. Turn the engine switch on (IG).

    3. Depress the brake pedal and check that the engine starts when the shift lever is in N or P, but does not start in any other position.

    4. Check that the back-up lights come on when the shift lever is moved to R, but do not come on in any other position. If the operation is not as specified, check the park/neutral position switch assembly for continuity.