PARK / NEUTRAL POSITION SWITCH REMOVAL


  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. B000KZ3

      Disengage the 3 grommets to remove the No. 1 engine cover sub-assembly.

      Note

      When removing the No. 1 engine cover sub-assembly, make sure to lift it upward. Pulling the No. 1 engine cover sub-assembly towards you may damage the No. 1 engine cover sub-assembly.

  2. REMOVE COOL AIR INTAKE DUCT SEAL


    1. B000MPY

      Remove the 9 clips and cool air intake duct seal.

  3. REMOVE INLET AIR CLEANER ASSEMBLY


    1. B000NQI

      Remove the 2 bolts and inlet air cleaner assembly.

  4. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    1. Connect the air cleaner cap with air cleaner hose to the throttle body with motor assembly.

    2. Install the air cleaner cap with air cleaner hose with the 2 guides and 2 air cleaner cap clamps.

    3. Tighten the hose clamp.

    4. Connect the union to connector tube hose to the air cleaner hose sub-assembly.

    5. Engage the wire harness clamp.

    6. Connect the mass air flow meter sub-assembly connector.

    7. Engage the ventilation hose clamp.

    8. Connect the ventilation hose to the cylinder head cover sub-assembly and slide the clip to secure it.

  5. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY


    1. Remove the air cleaner filter element sub-assembly from the air cleaner case sub-assembly.

  6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. B000LJY

      Disconnect the wire harness clamp.

    2. Remove the 2 bolts and air cleaner case sub-assembly.

  7. DISCONNECT ENGINE WIRE


    1. B000J0M

      Remove the nut from the wire harness clamp bracket.

    2. Disengage the clamp and disconnect the engine wire from the automatic transaxle assembly.

  8. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. B000LPE

      Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.

    3. B000IEP

      Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.

  9. REMOVE TRANSMISSION CONTROL SHAFT LEVER


    1. B000K3I

      Remove the nut, washer and transmission control shaft lever from the manual valve lever shaft sub-assembly.

  10. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. Disconnect the park/neutral position switch assembly connector.

    2. B000J3X

      Remove the 2 bolts and park/neutral position switch assembly from the transaxle case sub-assembly.

      Note

      Before removing the park/neutral position switch assembly, remove any dirt or rust on the installation portion of the manual valve lever shaft sub-assembly. Be sure to remove the park/ neutral position switch assembly straight along the manual valve lever shaft sub-assembly while being careful not to deform the plate spring that supports the manual valve lever shaft sub-assembly. If the plate spring is deformed, the park/neutral position switch assembly cannot be reinstalled correctly.