SHIFT LEVER (for TMMK Made) INSPECTION


  1. INSPECT LOWER SHIFT LEVER ASSEMBLY


    1. B000MG1E01
      Text in Illustration
      *a

      Component with harness connected

      (Shift Lock Control ECU)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      5 (IG) - Body ground Engine switch on (IG) 11 to 14 V
      Engine switch off Below 1 V
      4 (STP) - Body ground Brake pedal depressed 11 to 14 V
      Brake pedal released Below 1 V

      Tech Tips

      Do not disconnect the shift lock control ECU connector.

    2. B000MG1E02
      Text in Illustration
      *a

      Component with harness connected

      (Shift Lock Control ECU)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (E) - Body ground Always Below 1 Ω

      Tech Tips

      Do not disconnect the shift lock control ECU connector.

    3. Inspect shift lock solenoid:


      1. B000NBG

        Disconnect the shift lock solenoid connector.

      2. B000NNYE09
        Text in Illustration
        *a

        Front view of wire harness connector

        (to Shift Lock Solenoid)

        Measure the resistance according to the value(s) in the table below when the shift lever is moved to each position.

        Standard Resistance
        Tester Connection Shift Lever Position Specified Condition
        4 (P) - 3 (E2) P 10 kΩ or higher
        4 (P) - 3 (E2) Other than P Below 1 Ω

        • If the result is not as specified, replace the lower shift lever assembly.

        • If the shift lock does not operate when the power source of the lower shift lever assembly is normal and the resistance between the body ground and shift lock solenoid is as specified, replace the lower shift lever assembly.

      3. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 (SLS+) - 2 (SLS-) Always 112 Ω

        • If the result is not as specified, replace the lower shift lever assembly.

        • If the shift lock does not operate when the power source of the lower shift lever assembly is normal and the resistance between the body ground and shift lock solenoid is as specified, replace the lower shift lever assembly.