TRANSMISSION CONTROL CABLE REMOVAL


  1. REMOVE COOL AIR INTAKE DUCT SEAL


    1. B000MPY

      Remove the 9 clips and cool air intake duct seal.

  2. REMOVE INLET NO. 2 AIR CLEANER


    1. B000NQO

      Disconnect the 2 wire harness clamps and vacuum hose clamp.

    2. Remove the 2 bolts and inlet No. 2 air cleaner.

  3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. B000GYQ

      Disconnect the mass air flow meter connector and wire harness clamp.

    2. B000JRW

      Disconnect the 3 hoses.

    3. Separate the ventilation hose.

    4. B000K4N

      Loosen the hose clamp and separate the air cleaner cap sub-assembly from the throttle with motor body assembly.

    5. Release the 2 clamps and remove the air cleaner cap with hose.

  4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. B000JR9

      Disconnect the wire harness clamp, connector, vacuum hose and No. 1 fuel vapor feed hose.

    2. Remove the 2 bolts and air cleaner case sub-assembly.

  6. REMOVE AIRBAG SENSOR ASSEMBLY

    Click here

  7. REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY

    Note


    • Avoid physical shock to the accelerator pedal sensor assembly.

    • Do not disassemble the accelerator pedal sensor assembly.

    • The accelerator pedal sensor assembly does not require lubrication.

    • Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.


    1. B000NKP

      Disconnect the accelerator pedal sensor assembly connector.

    2. Remove the 2 bolts and accelerator pedal sensor assembly.

  8. DISCONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY


    1. Turn back the floor carpet.

    2. B000KO3

      Remove the bolt and nut, and disconnect the No. 1 parking brake cable assembly.

  9. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. B000KJQ

      Disconnect the end of the transmission control cable assembly from the lower shift lever assembly.

    3. Disengage the 2 claws and disconnect the transmission control cable assembly from the lower shift lever assembly.

    4. B000MDD

      Disconnect the wire harness clamp.

    5. B000MZZ

      Remove the nut and clip, and disconnect the transmission control cable assembly.

    6. B000KJJ

      Turn back the dash panel insulator.

    7. Remove the 2 bolts and pull out the transmission control cable assembly from the body.