STARTER (for 1.7 kW Type) INSTALLATION


  1. INSTALL STARTER ASSEMBLY


    1. Install the starter assembly with the 2 bolts.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    2. Connect the starter connector.

    3. Install the terminal nut and cover the nut with the cap.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

  2. INSTALL BATTERY

  3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

  4. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY


    1. Install the air cleaner cap sub-assembly with the 2 clamps.

    2. Install the air cleaner hose with the hose clamp.

    3. Connect the ventilation hose to the cylinder head cover.

    4. Install the fuel vapor feed hose to the air cleaner hose.

    5. Connect the mass air flow meter connector and 2 wire harness clamps to the air cleaner cap sub-assembly.

    6. Connect the vacuum switching valve assembly to the air cleaner hose.

  6. INSTALL INLET AIR CLEANER ASSEMBLY

  7. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

  8. INSTALL COOL AIR INTAKE DUCT SEAL

    for TMC, TMMR Made: Click here

    for TMMK Made: Click here

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.