STARTER REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE COOL AIR INTAKE DUCT SEAL


    1. B000MPY

      Remove the 9 clips and cool air intake duct seal.

  4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. B000KZ3

      Disengage the 3 grommets to remove the No. 1 engine cover sub-assembly.

      Note

      When removing the No. 1 engine cover sub-assembly, make sure to lift it upward. Pulling the No. 1 engine cover sub-assembly towards you may damage the No. 1 engine cover sub-assembly.

  5. REMOVE INLET AIR CLEANER ASSEMBLY


    1. B000NQI

      Remove the 2 bolts and inlet air cleaner assembly.

  6. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    1. B000K14

      Slide the clip and disconnect the ventilation hose from the cylinder head cover sub-assembly.

    2. Disengage the ventilation hose clamp.

    3. B000K4H

      Disconnect the mass air flow meter sub-assembly connector.

    4. Disengage the wire harness clamp.

    5. B000JRQ

      Disconnect the union to connector tube hose from the air cleaner hose sub-assembly.

    6. Disengage the 2 air cleaner cap clamps and 2 guides.

    7. B000L1M

      Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.

  7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY


    1. Remove the air cleaner filter element sub-assembly from the air cleaner case sub-assembly.

  8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. B000LJY

      Disconnect the wire harness clamp.

    2. Remove the 2 bolts and air cleaner case sub-assembly.

  9. REMOVE BATTERY


    1. B000NDI

      Loosen the nut, and disconnect the cable from the positive (+) battery terminal.

    2. Loosen the nut, and remove the bolt and battery clamp.

    3. Remove the battery and battery tray.

  10. REMOVE STARTER ASSEMBLY


    1. B000KX2E01
      Text in Illustration
      *1 Terminal Cap

      Open the terminal cap.

    2. Remove the nut and disconnect terminal 30.

    3. Disconnect the starter assembly connector.

    4. B000JPP

      Remove the 2 bolts and starter assembly.