REAR LOWER ARM (for TMMK Made) INSTALLATION

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

  • The rear No. 2 suspension arm assembly can be installed directly to the vehicle.


  1. INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY


    1. B000N9V

      Temporarily tighten the rear No. 1 suspension arm assembly (inner side) with the bolt.

      Text in Illustration
      B000K70 Bolt
      B000IB9 Front of the Vehicle
      B000NOZ Paint Mark

      Tech Tips

      Ensure that the paint mark faces the rear of the vehicle.

    2. B000I0RE07

      Set the rear No.1 suspension arm assembly in the position shown in the illustration, and fully tighten the bolt.

      Torque:
      100 N*m  { 1020 kgf*cm, 74 ft.*lbf }

  2. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

    Click here

  3. TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY


    1. B000IWK

      Temporarily tighten the rear No. 2 suspension arm assembly (inside) with the bolt.

      Text in Illustration
      B000K70 Bolt
      B000NOZ Paint Mark

      Tech Tips

      Ensure that the paint mark faces the rear of the vehicle.

  4. CONNECT REAR NO. 2 SUSPENSION ARM ASSEMBLY


    1. Connect the rear No. 2 suspension arm assembly (outer side) to the rear axle carrier sub-assembly with the bolt and nut.

      Note

      When temporarily tightening the bolt, keep the nut from rotating.

      Tech Tips

      Insert the bolt from the rear of the vehicle.

  5. STABILIZE SUSPENSION


    1. B000L6EE01
      Text in Illustration
      *1 Wooden Block

      Jack up the rear axle carrier sub-assembly, placing a wooden block under it to avoid damage. Apply load to the suspension so that the installed bolt of the rear No. 1 suspension arm assembly (inner side) is horizontally aligned with the center of the rear axle hub.

      CAUTION:

      Do not jack up the rear axle carrier sub-assembly too high as the vehicle may fall.

      Note


      • When jacking up the rear axle carrier sub-assembly, be sure to jack it up slowly.

      • Make sure to perform this operation with the vehicle kept as low as possible.

  6. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY


    1. B000HKT

      Fully tighten the 2 bolts.

      Torque:
      100 N*m  { 1020 kgf*cm, 74 ft.*lbf }

  7. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (for RH Side)

    Click here

  8. INSTALL REAR WHEELS

    Torque:
    103 N*m  { 1049 kgf*cm, 76 ft.*lbf }

  9. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here

  10. HEIGHT CONTROL SENSOR SIGNAL INITIALIZE (for RH Side)

    Click here

  11. ADJUST HEADLIGHT AIMING (for RH Side)

    Click here