REAR DOOR BELT MOULDING(for Hatchback, Wagon) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. PRECAUTION (w/ Power Window)

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Power Window)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE REAR ARMREST ASSEMBLY (w/o Power Window)

    Click here

  4. REMOVE REAR ARMREST ASSEMBLY (w/ Power Window)

    Click here

  5. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click here

  6. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

    Click here

  7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  8. REMOVE REAR DOOR SERVICE HOLE COVER

    Click here

  9. DISCONNECT REAR DOOR WEATHERSTRIP


    1. B004301

      Disengage the clip and disconnect the rear door weatherstrip.

  10. DISCONNECT REAR DOOR GLASS RUN

    Click here

  11. REMOVE REAR DOOR REAR WINDOW GUIDE WITH REAR DOOR REAR GUIDE SEAL

    Click here

  12. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  13. REMOVE REAR DOOR GLASS RUN

    Click here

  14. REMOVE REAR DOOR BELT MOULDING ASSEMBLY


    1. Resin Type:


      1. B0041ZJC04
        *a Protective Tape
        B0042RQ Protective Tape

        Put protective tape around the rear door belt moulding assembly.

      2. Using a screwdriver with its tip wrapped with protective tape, disengage the 6 claws and remove the rear door belt moulding assembly as shown in the illustration.

        Tech Tips

        Tape the screwdriver tip before use.

    2. Plating Type:


      1. B0042OIC04
        *a Protective Tape
        B0042RQ Protective Tape

        Put protective tape around the rear door belt moulding assembly.

      2. Using a screwdriver with its tip wrapped with protective tape, disengage the 5 claws and remove the rear door belt moulding assembly as shown in the illustration.

        Tech Tips

        Tape the screwdriver tip before use.