REAR DOOR BELT MOULDING(for Sedan) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY

   
   

   1. for Resin Type:

      
      

      1. 

         Engage the 8 claws to install the rear door belt moulding assembly.

   2. for Plating Type:

      
      

      1. 

         Engage the guide and 7 claws to install the rear door belt moulding assembly.

2. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

   Click here

3. INSTALL REAR DOOR QUARTER WINDOW GLASS

   Click here

4. INSTALL REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

   Click here

5. INSTALL REAR DOOR GLASS RUN

   Click here

6. CONNECT REAR DOOR WEATHERSTRIP

   
   

   1. Engage the clip and connect the rear door weatherstrip.

7. INSTALL REAR DOOR SERVICE HOLE COVER

   Click here

8. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

   Click here

9. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

   Click here

10. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

    Click here

11. INSTALL REAR DOOR ARMREST UPPER BASE PANEL (w/o Power Window)

    Click here

12. INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click here

13. INSTALL REAR ARMREST ASSEMBLY

    Click here

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Power Window)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

15. INITIALIZE POWER WINDOW CONTROL SYSTEM (w/ Power Window)

    Click here

16. INSPECT POWER WINDOW OPERATION (w/ Power Window)

    Click here