FRONT BUMPER(for Hatchback, Wagon) INSTALLATION

PROCEDURE


  1. INSTALL FRONT BUMPER ASSEMBLY


    1. w/ Headlight Cleaner System:


      1. Connect the headlight cleaner hose.

    2. w/ TOYOTA Parking Assist-sensor System:


      1. Connect the ultrasonic sensor connector.

    3. A01M17W

      Move the front bumper assembly into position and install the 2 clips.

    4. Install the bolt.

    5. w/ Fog Light:


      1. Pull back the side of the front bumper assembly and connect the 2 fog light connectors.

        Note

        Do not apply excessive force when pulling back the side of the front bumper assembly.

    6. A01LXRK

      Engage the 3 claws.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    7. Install the 6 screws.

    8. A01LYO2C03
      *1 Pin Hold Clip
      *a Correct
      *b Incorrect

      Install the pin hold clip as shown in the illustration.

      Note

      Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    9. Install the front bumper assembly with the clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

  2. INSTALL FRONT SPOILER PROTECTOR

    Click here

  3. ADJUST FOG LIGHT ASSEMBLY (w/ Fog Light)

    Click here

  4. ADD WINDSHIELD WASHER FLUID (w/ Headlight Cleaner System)

    Click here