FRONT BUMPER(for Sedan) INSTALLATION

PROCEDURE


  1. INSTALL FRONT BUMPER ASSEMBLY


    1. w/ Headlight Cleaner System:


      1. Connect the headlight cleaner hose.

    2. w/ TOYOTA Parking Assist-sensor System:


      1. Connect the ultrasonic sensor connector.

    3. A002ZM3

      Move the front bumper assembly into position as shown in the illustration.

    4. Install the 3 clips.

    5. Pull back the side of the front bumper assembly and connect the connector.

      Note

      Do not apply excessive force when pulling back the front bumper assembly.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    6. A003183

      Engage the 4 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    7. Install the 8 screws.

    8. A0030GGC01
      *1 Pin Hold Clip
      *a Correct
      *b Incorrect

      Install the pin hold clip as shown in the illustration.

      Note

      Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    9. Install the front bumper assembly with the clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

  2. INSTALL RADIATOR GRILLE SUB-ASSEMBLY

    Click here

  3. ADJUST FOG LIGHT ASSEMBLY (w/ Fog Light)

    Click here

  4. ADD WINDSHIELD WASHER FLUID (w/ Headlight Cleaner System)

    Click here