FRONT BUMPER(for Sedan) REMOVAL

PROCEDURE


  1. REMOVE RADIATOR GRILLE SUB-ASSEMBLY

    Click here

  2. REMOVE FRONT BUMPER ASSEMBLY


    1. A0030YXC01
      A00301U Protective Tape

      Apply protective tape around the front bumper assembly as shown in the illustration.

    2. A002ZTOC01
      *1 Pin Hold Clip
      *a 90°

      Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. Remove the clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. A0030SX

      Remove the 8 screws.

    5. A0030I3

      Disengage the 4 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    6. Pull back the side of the front bumper assembly and disconnect the connector.

      Note

      Do not apply excessive force when pulling back the front bumper assembly.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    7. A002ZOP

      Using a clip remover, remove the 3 clips.

    8. w/ TOYOTA Parking Assist-sensor System:


      1. Disconnect the ultrasonic sensor connector.

    9. w/ Headlight Cleaner System:


      1. Disconnect the headlight cleaner hose and drain the washer fluid.

        Tech Tips

        Use a container to collect the washer fluid.

    10. A002ZUT

      Remove the front bumper assembly as shown in the illustration.