FRONT BUMPER(for Sedan) REMOVAL

PROCEDURE


  1. REMOVE RADIATOR GRILLE SUB-ASSEMBLY

    Click here

  2. REMOVE FRONT BUMPER ASSEMBLY


    1. A012HG8C01
      A012F6O Protective Tape

      Put protective tape around the front bumper assembly.

    2. A012MQKC01
      *1 Pin Hold Clip
      *a 90°

      Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. Remove the clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. A012MNP

      Remove the 8 screws.

    5. A012FXN

      Disengage the 4 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    6. A012H6N

      Using a clip remover, remove the 3 clips.

    7. A012J2P

      Disengage the 4 claws as shown in the illustration.

    8. w/ Fog Light:


      1. Pull back the side of the front bumper assembly and disconnect the 2 fog light connectors.

        Note

        Do not apply excessive force when pulling back the front bumper assembly.

    9. w/ TOYOTA Parking Assist-sensor System:


      1. Disconnect the ultrasonic sensor connector.

    10. w/ Headlight Cleaner System:


      1. Disconnect the headlight cleaner hose and drain the washer fluid.

        Tech Tips

        Use a container to collect the washer fluid.

    11. Remove the front bumper assembly.