HEIGHT CONTROL SENSOR INSTALLATION

PROCEDURE

1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (for Double Wishbone Type Suspension)

   
   

   1. Install the rear height control sensor sub-assembly with the 2 bolts.

      Torque:

      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

   2. Engage the clamp.

   3. Connect the connector.

2. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (for Torsion Beam Type Suspension)

   
   

   1. Engage the 2 guides.

   2. Install the rear height control sensor sub-assembly with the 3 bolts.

      Torque:

      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

   3. Connect the connector.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

4. INITIALIZE HEIGHT CONTROL SENSOR SIGNAL

   Click here

5. ADJUST HEADLIGHT AIMING

   Click here