HEIGHT CONTROL SENSOR REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (for Double Wishbone Type Suspension)


    1. B0043RU

      Disconnect the connector.

    2. Disengage the clamp.

    3. Remove the 2 bolts and rear height control sensor sub-assembly.

      Note

      Do not drop the rear height control sensor sub-assembly. If it is dropped, replace it with a new one.

  4. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (for Torsion Beam Type Suspension)


    1. B0044O2

      Disconnect the connector.

    2. Remove the 3 bolts.

    3. Disengage the 2 guides to remove the rear height control sensor sub-assembly.

      Note

      Do not drop the rear height control sensor sub-assembly.If it is dropped, replace it with a new one.