STOP LIGHT SWITCH INSTALLATION

PROCEDURE


  1. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER


    1. Engage the 2 claws to install the stop light switch mounting adjuster.

  2. INSTALL STOP LIGHT SWITCH ASSEMBLY


    1. A01T96T

      Insert the stop light switch assembly until the threaded sleeve hits the pedal.

      Note

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

    2. A01T8SRC01

      Turn the stop light switch assembly a quarter turn clockwise to install the stop light switch assembly.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf }
      or less

      Note

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

    3. Connect the connector.

    4. Check the protrusion of the plunger.

      Protrusion of the Plunger
      Area Measurement
      a 0.5 to 2.6 mm (0.0197 to 0.102 in.)

      If the protrusion is not as specified, recheck switch installation and inspect brake pedal adjustment if necessary.

      for LHD: Click here

      for RHD: Click here

      Note

      Do not depress or support the brake pedal.

  3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Instrument Panel Under Cover)

    for Sedan: Click here

    for Hatchback, Wagon: Click here