LICENSE PLATE LIGHT ASSEMBLY(for Wagon) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

  • The license plate light bulb can be replaced by removing only the license plate light lens. It is not necessary to remove the license plate light assembly.

PROCEDURE


  1. REMOVE BACK DOOR UPPER TRIM PANEL ASSEMBLY

    Click here

  2. REMOVE BACK DOOR SIDE GARNISH LH

    Click here

  3. REMOVE BACK DOOR SIDE GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  4. REMOVE DOOR PULL HANDLE

    Click here

  5. REMOVE BACK DOOR TRIM PANEL ASSEMBLY

    Click here

  6. REMOVE LICENSE PLATE LIGHT ASSEMBLY


    1. A012GKI

      Disconnect the connector.

    2. Disengage the 2 claws to remove the license plate light assembly.

  7. REMOVE LICENSE PLATE LIGHT PACKING


    1. A012HAJ

      Remove the license plate light packing.

      Note

      Do not reuse the removed license plate light packing. Be sure to install a new license plate light packing to prevent water ingress.

  8. REMOVE LICENSE PLATE LIGHT LENS


    1. A012JY9C01
      *a Insert into the hole
      A012F6O Protective Tape

      Insert a screwdriver wrapped with protective tape into the license plate light lens hole, tilt it as shown in the illustration and disengage the 2 claws to remove the license plate light lens.

  9. REMOVE LICENSE PLATE LIGHT BULB


    1. A012LB3

      Remove the license plate light bulb.