LICENSE PLATE LIGHT ASSEMBLY(for Sedan) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

  • The license plate light bulb can be replaced by removing only the license plate light lens. It is not necessary to remove the license plate light assembly.

PROCEDURE


  1. REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY

    Click here

  2. REMOVE LICENSE PLATE LIGHT ASSEMBLY


    1. A01TCD0

      Disconnect the connector.

    2. Disengage the 2 claws to remove the license plate light assembly.

  3. REMOVE LICENSE PLATE LIGHT PACKING


    1. A01TDIM

      Remove the license plate light packing.

      Note

      Do not reuse the removed license plate light packing. Be sure to install a new license plate light packing to prevent water ingress.

  4. REMOVE LICENSE PLATE LIGHT LENS


    1. A01TCVRC01
      *a Insert into the hole
      A01TCKT Protective Tape

      Insert a screwdriver wrapped with protective tape into the license plate light lens hole, tilt it as shown in the illustration and disengage the 2 claws to remove the license plate light lens.

  5. REMOVE LICENSE PLATE LIGHT BULB


    1. A01TANJ

      Remove the license plate light bulb.