REAR COMBINATION LIGHT ASSEMBLY(except Sedan) INSPECTION

PROCEDURE

1. INSPECT REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH

   
   
   1. 

      *a	Component without harness connected (Rear Combination Light Socket and Wire Sub-assembly LH)

      Disconnect the rear combination light assembly LH connector.

   2. Apply battery voltage to the rear combination light socket and wire sub-assembly LH and check that the lights come on.

      OK
      Condition Specified Condition Battery positive (+) → Terminal 1 (B) Battery negative (-) → Terminal 3 (E) The stop light comes on Battery positive (+) → Terminal 2 (TL) Battery negative (-) → Terminal 3 (E) The taillight comes on Battery positive (+) → Terminal 4 (TRN) Battery negative (-) → Terminal 3 (E) The turn signal light comes on

      If the result is not as specified, repair or replace the rear combination light socket and wire sub-assembly LH.

2. INSPECT REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY RH

   
   
   1. 

      *a	Component without harness connected (Rear Combination Light Socket and Wire Sub-assembly RH)

      Disconnect the rear combination light assembly RH connector.

   2. Apply battery voltage to the rear combination light socket and wire sub-assembly RH and check that the lights come on.

      OK
      Condition Specified Condition Battery positive (+) → Terminal 1 (B) Battery negative (-) → Terminal 3 (E) The stop light comes on Battery positive (+) → Terminal 2 (TL) Battery negative (-) → Terminal 3 (E) The taillight comes on Battery positive (+) → Terminal 4 (TRN) Battery negative (-) → Terminal 3 (E) The turn signal light comes on

      If the result is not as specified, repair or replace the rear combination light socket and wire sub-assembly RH.